mardi 21 août 2012


DIY HAIR NECKLACE


In this beautiful world of buns + top knots, we’re always searching for ways to mix it up. Today’s DIY helps us do just that! Making hair jewelry can be really fun & it’s very likely that you’ll have most of these supplies already at home! You can take apart an inexpensive multi-strand chain necklace that you don’t wear anymore, or if you don’t have that you can go to a bead shop where they sell chain and necklace making supplies. Here’s how I created this golden goodness:
photos+ tutorial by Kristin Ess
TOOLS: Wire cutters, flat-head pliers, thin gold wire, strands of necklace chain, a brass loop, a small hair comb + a bobby pin that matches your hair color. (FYI, all of the metal used here can be found at a bead store if you don’t have a necklace to take apart at home!)
  1. Open the brass loop.
  2. String your first chain on to the loop.
  3. Continue stringing chain until you have as many as you want on there. I only used 4.
  4. Use your flat-head pliers to close the brass loop back up.
  5. Slide your bobby pin through the brass loop.
  6. Cut your chains using your wire cutters. I cut each one about half an inch longer than the next. That way they have a draped look and fall about half an inch apart!
  7. Cut a piece of thin wire. You want to cut the wire about 3 times the length of your comb so you have enough to wrap. (see photo)
  8. Wrap your piece of wire around the first prong of your comb. I wrapped it three times to make sure it stays put! After you wrap it, tighten it using your flat-head pliers.
  9. String your shortest chain on the first loop.
  10. Now wrap your wire around the top of your comb and back under. Loop it around once or twice.
  11. Continue stringing your chain and then looping the wire around. You’ll want to go from shortest to longest so that the longest chain will hang the lowest.
  12. Once you’ve finished stringing your chains, tighten it off with flat-head pliers.

Aucun commentaire:

Enregistrer un commentaire